logo_perpagine_giallo.GIF (7552 byte)




These machines are produced in a wide range of models for bending of up to 50-mm diameter rods. They are suitable for installation at sites and in pre-fabrication shops.

The OSCAM special, patented bending system, which uses a central fixed pin, ensures that the rods are not pulled or stretched during bending, thus assuring high level precision.

They make it possible to obtain any bending angle with automatic return to the starting point.

These machines are renowned for their exceptional sturdiness, their legendary service life and extremely easy maintenance.

Most models can be fitted with the "Easy Angle" electronic programmer on which the sequences of bends are programmed with different angles up to a maximum of 60 figures in addition to the standard shapes already stored.

The Easy Angle is complete with cycle counter, self-test and up to 90 angle corrector.


e-mail OSCAM S.p.A.info@oscam.com